Sears 200.71226 User Manual

OWNER^S MANUALDieHardMicroprocessor Controlled, Fully Automatic Operation Battery Charger with Engine StarterPlus Battery and Alternator Tester2-AMP S

71226 CONTROL PANEL GUIDEMODE OF OPERATIONP ^c}"^<27^/^ VT___^V-cCo ^XT‘Vk'' ^ <<?Sf&DigitalDisplayInitial power-up, bat

USING THE BUILT-IN BATTERY TESTEROVERVIEWThis battery charger has a built-in battery tester that displays either an accurate battery voltage or an est

USING THE BUILT-IN ALTERNATOR TESTERThis battery charger has a built-in alternator tester that displays either an accurate alternator voltage or an

BATTERY PERCENT AND CHARGE TIMEThis charger adjusts the charging time in order to charge the battery completely, efficiently and safely. The microproc

CHARGING TIPSRead this entire manual before using your charger. The tips below serve only as a guide for specific situations.If your vehicle won’t sta

TROUBLESHOOTINGPerformance problems often can be corrected by the user. Please read through this chart for a possible solution to common problems.PROB

PARTSThis section shows an illustration of your battery charger. Use it to become familiar with part locations and appearance.Replacement Parts List S

TABLE OF CONTENTSWARRANTY...2IMPORTANT SAF

IMPORTANT SAFETY INSTRUCTIONSWARNING - RISK OF EXPLOSIVE GASESWORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE G

Never place charger directly above battery being charged. The gases from the battery will corrode and damage the charger.Never touch the battery clamp

BEFORE USING YOUR BATTERY CHARGERIt is important to understand your charger's requirements. This section will tell you about your charger's

OPERATING INSTRUCTIONSNOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requires equipment specially desi

CHARGING BATTERY REMOVED FROM THE VEHICLE:POSITIVE NEGATIVE1. Note the polarity of the battery posts by checking the identification marks on the batte

in seconds. It starts at 5 and counts down to 0.3. Cool Down - After cranking, the charger enters a mandatory 3-minute (180 second

If the charge mode is changed after charging has started (by pressing the CHARGE RATE or CHARGE TYPE button), the charging process