Sears 200 Owner's Manual download pdf (Page 6)

3. Tap the other axle cap onto the opposite end of the

axle and place the axle assembly onto the bottom of

the charger. Place one end of the bracket into slot,

then place the axle assembly under each bracket.

Fasten the other side of the brackets using the two

10-32 screws provided.

To attach the handle:

Turn the charger right side up onto its foot and wheels.

Remove the two top screws from each side of the

charger and align with the screw holes on the handle.

Attach the handle using the same screws.

Plugging it in

Electrical Shock Hazard

Be sure that power cord fits properly into outlet.

If not, have a qualified technician install a proper

outtet. Never alter the AC cord or plug provided.

Improper connection can result in electrical shock.

Your charger should be grounded to reduce the risk

of electrical shock.

Your charger is equipped with an electrical cord that

has an equipment grounding conductor and a ground-

ing plug designed to be used on a 120 volt circuit. The

plug must be plugged into an outlet that has been

properly installed and grounded in accordance with all

local codes and ordinances.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Sears 200 Owner's Manual Page 6