Sears 721.85062 User Manual download pdf (Page 10)

ENGLISH

STEP 3 : PREPARE THE VENTING BLOWER

Pulling and stretching the blower wiring could result

inelectrical shock.

• 



Before You Start

1. Remove any shipping materials and parts from

inside the microwave oven.

2. Cover the counter top or cooktop with a thick,

protective covering to protect it from damage and

dirt. See Figure 11.

NOTE: If you have a free-standing range, disconnect

it, move it onto a piece of cardboard or

hardboard and pull it away from the wall,

so that you can get closer to the upper

cabinet and back wall for easier measuring

and drilling.



1. Remove mounting plate screw(s) (1 or 2 screws)

from the mounting plate as shown and discard.

See Figure 12.

2. This plate will be used as the rear mounting plate.

(It will be used to locate and mark the mounting

holes on the rear wall.)

3. Locate exhaust adapter, grease filters and

hardware packet.

4. At this point, remove any adhesive tape (If there is

any), on the exhaust adapter, the grease filters

and the power supply cord.



This oven is shipped assembled for room-vented.



1. Remove one blower unit mounting screw and one

or two blower plate screw(s). Remove the blower

plate from cabinet. See Figure 13.

2. Carefully lift the blower unit out of the microwave

oven.

3. Use side cutters or thin snips to cut and remove

knockouts “B” from Back plate. Discard knockouts.

Be careful not to distort the plate. See Figure 14.







WARNING

A thick, protective

covering

Mounting plate

Blower Plate

Back Plate

Blower Plate

Mouning Screw (option)

Blower Unit

Mounting Screw (option)

Knockouts Parts “B”

Parts " B"

Blower Unit

Mounting plate screw(s)

(1 or 2 screws)

Mounting plate screw(s)

(1 or 2 screws)

Control Panel Side

A thick, protevtive

covering

Control Panel Side

Figure 11

Figure 12

Figure 13

Figure 14

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Sears 721.85062 User Manual Page 10

Comments to this Manuals

Related products and manuals for Microwaves Sears 721.85062