Sears Kenmore Vacuum Cleaner User Manual download pdf (Page 12)

SUCTION MOTORRESET

The suction motor reset will shut the motor off if air-

flow is sufficiently restricted to cause motor overheat-

ing and possible damage to the vacuum cleaner.

Once the reset goes into effect, the vacuum cleaner

will not operate for approximately 10 minutes. At this

time the unit should be unplugged from the electri-

cal outlet and checked for clogging. Follow the

instructions under "CLOG REMOVAL" on page 15.

Even though dust bags may appear to be not full,

there are times when airflow through them may

become severely restricted. Thiscan happen from

picking up fine dust particle materials such as plaster

dust, talc or other powders. These materials can clog

the pores in the bag and close off airflow, causing

the reset button to go into effect. If this condition

exists, the bag must be changed. See "BAG CHANG-

ING" instructions staffing on page 9.

When all airflow passages are clean, the dust bag

• has been checked to be satisfactory, and approxi-

mately 10 minutes have passed, use a pencil, ball

point pen tip or similar item to push the reset button

back in. See nstruct ons n the Ilustrat on to the right.

The reset button must be pushed in for the vacuum

cleaner to resume operation.

SUCTIONMOTORRESET

IF SHUTDOWNOCCURS,CHECK

FORFULL BAGOR CLOGGEDHOSE.

(SEEOPERATOR'SMANUAL)

WAITAPPROXIMATELY10 MINUTES

BEFOREATTEMPTINGRESET.

USE BALLPOINTPENFOR RESET.

Set the unit upright, plug the power cord in and

restart the unit. If it does not restart, wait an addition-

al five minutes. Try again. If it still does not staff, call

Sears for service.

TCHANGING,BRUSHCHANGING

ANDBRUSHCLEANING

ElectricalShockOr PersonalInjuryHazard

Disconnectelectrical supplybefore servicingor

cleaning the unit.Failureto do so could resultin

electrical shockor personalinjuryfromcleaner sud-

denly starting.

Frequently check and remove hair, string and lint

build-up in the brush area. If build-up becomes

excessive, follow the steps below. Should the belt

become loose or should it break, follow the Belt

Removal instructions.

TOREMOVEBELT:

Disconnect electrical supply.

The handle must be pulled down and the cleaner

turned over.

Release the lower plate by pushing the tabs in

toward the center,

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Sears Kenmore Vacuum Cleaner User Manual Page 12

Comments to this Manuals