Sears SRD2900 Instruction Manual download pdf (Page 14)

HOOKUPS

If your TV does not have A/V terminals:

When the DVD/VCR COMBINATION UNITS is in the

VCR Playback mode or when the DVD/VCR COMBI-

NATION UNITS is in the VCR mode, your TV will

receive signals from the DVD/VCR COMBINATION

UNITS on either channel 3 or channel 4. To use the

DVD/VCR COMBINATION UNITS with your TV, set

the selector switch to CH3 or CH4 (which is located in

the back of your DVD/VCR IK_

COMBINATION UNITS),

whichever is not used for nor-

mal broadcasts in your area.

Then set your TV to the same

channel.

1. Disconnect the AC power cord of the TV from the

AC outlet.

2. Disconnect the antenna or cable from the TV.

3. Connect the antenna or cable to the ANT-IN jack of

the DVD/VCR COMBINATION UNITS.

4. Connect the DVD/VCR COMBINATION UNITS to

the TV using the RF cable.

5. Plug the AC power cords of the DVD/VCR COMBI-

NATION UNITS and TV into the AC outlets.

[VHF/UHF [Indoorantenna] [Backoflhe DVDNCR]

¢omlmnal+onantenna] % / _- [BackofIhe

" '_ 11 U+NHF_+n.,o.rVl

_mz,,+.-I-.._],_ (stJpplm¢I 1

[c++_+,++s+to,,eb+,]o.1 II -_. _.._<+_+.F_ l

pan,/ [Back of the DVDNCR]

Note to CATV system installer , I

This reminder is provided to call the CATV system installer s attention to Article 820-40 of the NEC that pro- ]

rides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected

to the grounding system of the building, as close to the point of cable entry as practical.

Antenna,+ *00

A/V-compatible or I .

wide screen TV _ _ _1Ot_

t---_-- _ ToANqLINI I -

/1_ I11._o VIDEO IgPUT)aek To VIDEO OUT)ack

Notes _ _ _ [ _ To AUDIO INPUT jacks To AUDIO OUT jacks

• Connect the DVD/VCR COMBINATION UNITS directly to a TV. If the A/V cables are connected to a

VCR, pictures may be distorted due to the copy protection system.

[Fig. 1]

FOR TVs WITH S-VIDEO INI'UT JACK

Use an S-Video cable (commercially available) in place of the yellow video cable to enjoy higher quality pictures.

Note

• The S-Video connection only supplies video (picture) in the DVD mode of the DVD/VCR COMBINATION

UNITS. Therefore, in order to use the VCR features or view TV channels on the DVD/VCR COMBINATION

UNITS, you still need to either connect the RF cable to the ANT-OUT jack of the DVD/VCR COMBINATION

UNITS and the TV's Antenna In jack, or connect the yellow video cable as described earlier (Fig. 1). To connect

the supplied RF cable, see "DVD/VCR TO TV CONNECTION" above.

A/V-compatible or H . _ 0_'_

wide screen TV _l/_° _-

oooio I

I//-0---, ToRight(red)andLeft<white> /

III III +o UOiO,+U+jook+ToAUDIOOUTjacks I

-_J9 [IlS_aT° S-VIDEO INPUTiack To S-VIDEO OUT)ack| [Fig. 2]

- 14- EN

IL25

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments

Sears SRD2900 Instruction Manual Page 14

Comments to this Manuals

Related products and manuals for DVD players Sears SRD2900