721.80513721.80602721.80603721.80604721.80609721.80822721.80823721.80824721.80829721.80832721.80833721.80834721.80839Read and save theseinstallation i
STEP 3:PREPARE THE VENTING BL 0 WERYour microwave oven is shipped with the blower assembled for room venting (recirculating). You need to adjustthe bl
STEP 3:PREPARE THE VENTING BLOWERWALL VENTED INSTALLATION:1. Remove blower unit mounting screw(s) and blowerplate screw(s). Remove the blower plate fr
STEP 3:PREPARE THE VENTING BL 0 WERROOF VENTED INSTALLATION:1,2,Remove blower unit mounting screw(s) and blowerplate screw(s). Remove the blower plate
STEP 4: PREPARE THE WALL ANDUPPER CABINET FOR INSTALLATIONMEASURE AND TACK / TAPE UP THETEMPLATE1. Using a plumb line and (metal) measuring tape, find
STEP 4: PREPARE THE WALL ANDUPPER CABINET FOR INSTALLATIONDRILL THE HOLES IN THE WALL AND UPPER CABINET.WARNINGBE VERY CAREFUL WHEN DRILLING HOLES INT
STEP 5: INSTALL THE MOUNTINGPL ATE TO THE WALLTHE OVEN MUST BE CONNECTEDTO AT LEAST ONE WALL STUD.1. Draw a vertical line on the wall at the center of
STEP 5: INSTALL THE MOUNTINGPLATE TO THE WALLTO PREPARE THE REAR WALLCUTOUT OPENING AND EXHAUSTADAPTOR/MOUNTING PLATE FORWALL VENTING AND ROOFVENTING:
STEP 6:ATTACH THE 0 VEN TO THE WALL_, WARNING _,You will need two people to lift thismicrowave. Failure to use morethan one person could result inpers
STEP 6:ATTACH THE OVEN TO THE WALLI5. Roof vented installation: See Figure 32.Install ductwork through the vent opening in theupper cabinet. Complete
YOUR SAFETY FIRSTBEFORE YOU START• Proper installation is the installer's responsibility!- Read the entire manual before you begin.- The model nu
YOUR SAFETY FIRST• THIS APPLIANCE MUST BE GROUNDED!- If there is an electrical short circuit, grounding reduces the risk of electrical shock by provid
YOUR SAFETY FIRST• MAKE SURE YOU HAVE ENOUGH SPACE AND SUPPORT.- Mount the oven against a flat, vertical wall, so that it is supported by the wall. Th
PARTS, TOOLS, MATERIALSTHE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:NOTE: Depending on your ventilation requirements, you may not use all of these p
PAR TS, TO0 LS, MATER IALSYOU WILL NEED THE FOLLOWING TOOLS AND MATERIALS FOR THEINSTALLATION:Carton or other heavy material for covering the counter
STEP 1: PREPARE THEELECTRICAL CONNECTIONS_, WARNING AAVOID ELECTRICAL SHOCK! THIS APPLIANCE MUST BE GROUNDED!1. Locate the grounded electric outlet fo
STEP 2:PREPARE THE VENTING S YSYTEMNOTE: The ductwork you need for outside ventilation is not included with your oven. The standard ductworkfittings a
STEP 2:PREPARE THE VENTING SYSTEMSTANDARD FITTINGSNOTE: If the existing duct is round, you must use a rectangular-to-round adapter, with a rectangular
Comments to this Manuals