Sears 486.248392 Owner's Manual download pdf (Page 13)

Hold this drawing above you while viewing the

Clutch/idler Assembly from underneath the

tractor. Right and left in the drawing will be the

reverse of the viewer's right and left.

ENGINE Le_de

PULLEY of T_c_r

KEEPER

I_"HAIRPIN

COTTER

IDLER

BOLT

FIGURE 22 VIEWED FROM UNDERNEATH

ASSEMBLY OF THE SNOW THROWER

Place the lift handle into the lift bracket on the right

side of the snow thrower. Fasten the handle to the

bracket using two 5/16" x 1-3/4" hex bolts, 5/16"

lock washers and 5/16" hex nuts. See figure 23.

LIFT HANDLE

5116" HEX NU'i"

_ 5/16" x 1-3/4"

HEX BOLT

5/16" LOCK

WASHER LIFT BRACKET

FIGURE 23 RIGHT SIDE VIEW

NOTE: Be sure the lift release cable's plastic covering

remains inserted into the trigger assembly while

performing the next step.

• Push the lift handle down into the locked position.

Insert the end of the cable wire into the hole in the

lift rod. Place the threaded fitting into the slot in the

lift bracket, with one hex nut above and one hex

nut and the lock washer below the slot. Tighten the

nuts, adjusting them to eliminate slack in the cable

wire. See figure 24. Refer also to the Service and

Adjustments section on page 20 in this manual.

HINT: For easier assembly of the lift release cable, tilt

the snow thrower forward onto the spiral auger.

__ IFT RELEASE

CABLE

HEX NUT

ASSEMBLY

LOCK

_1 WASHER

??/ .°,.,,

/" \ _ )"ql.---_ _ CABLE

h 1_WIRE

_ "<"" "-----_ _ LIFT

-ROB

FIGURE 24 RIGHT SIDE VIEW

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Sears 486.248392 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Snow throwers Sears 486.248392