TROUBLE-SHOOTING AND STORAGE
Most treadmill problems can be solved by following the slmple steps below.: Rnd the symptom that applies,
and followthe steps listed. If further assista_ Is ne_d_l, call our Customer Se_,ice'Department t011-freeat
1-800-999-3756, Monday through Friday, 6 a.m.until 6 p.m, Mountain Time, _
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a properly grounded outlet. (See PLUGGING IN THE
POWER CORD on page 7.) If an extension cord is needed, use only a 14-gauge general-purpose cord of
five feet or less in length.
b. After the power cord has been plugged in, make sure that the safety key is fully inserted into the console.
Various indicatorson the console should light. (See TURNING ON THE POWER on page 8.)
c. Check the circuit breaker located on the treadmill near the
power cord. If the switch protrudes as shown, the circuit break-
er has tripped. To reset the circuit breaker, wad for five min-
utes and then press the switch back in.
d. Check the on/off switch located on the treadmill near the
power cord. The switch must be in the ON position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
Tripped
a. Check the circuit breaker located on the treadmill near the power cord. If the circuit breaker has tripped (see
the drawing above), wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the safety key from the console. Reinsert the safety key fully into the console. Vadous indicators on
the console should light.
d. Check to makesure the on/off switch is in the ON position. (See 1. d. above.)
e. If the treadmill stillwill not run, please call our Customer Service Department.
10
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a_
Apply silicone lubricant to the walking platform before use._Reapply lubricant after every 10 hours of use,
and whenever a decrease in performance is noticed. (UnioSport silicone spray is recommended.) CAUTION:
UNPLUG THE POWER CORD WHEN APPLYING LUBRICANT. (See OPERATION AND ADJUSTMENT
on page 7 for application instructions.)
b. If an extensioncord is needed, use only a 14-gauge general-purpesocord of fivefeet or less inlength.
C.
If the walking belt,is overtightened, treadmill performance may
decrease and the walking belt may be permanently damaged.
Remove the safety key and UNPLUG THE POWER CORD.
Usingthe 3/16" allen wrench, tum both rear roller adjustment
bolts counterclockwise, 114of a turn. When the walking belt is
properlytightened, you should be able to lifteach side of the
walking belt 3-4 Inches off the walking platform. The center of
the walking belt should just touch the walking platform. Be care-
ful to keep the walking belt centered. P!ug in the power cord,
insert the safety key and run the treadmill for a few minutes.
Repeat untilthe walking belt is properly tightened.
Rear Roller Adjustment Bolts
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals