Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual download pdf (Page 5)

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.

The parts supplied are in the washer drum.

Tools needed for connecting the water inlet hoses

■ Pliers

■ Flashlight (optional)

Tools needed for installation

■ Open end wrenches 17 mm and 13 mm

■ Level

■ Wood block

■ Ruler or measuring tape

Parts supplied

(use for the upper bolt hole)

Wrench Bolt hole covers

Hose guide Water supply hose

Alternate Parts

Parts listed are available from your local Sears store or Sears

Service Center. For further information, please call 1-800-4-MY-

HOME® (1-800-469-4663).

If You Have You Will Need to Buy

Laundry tub or

standpipe taller than

96" (2.4 m)

Sump pump system (if not already

available)

Overhead sewer Standard 20 gal. (76 L), 30" (76.2 cm)

tall drain tub or utility sink and sump

pump (available from local plumbing

suppliers)

Drain hose too short 3.3 ft (1.0 m) drain hose extension kit,

Part Number DC82-01012A

Options

Pedestal

You have the option of purchasing a pedestal for this washer.

You may select a 10.6" (27 cm) pedestal. Remember that the

pedestal will add to the total height of the unit.

To order, call your local Sears store. For further information,

please call 1-800-4-MY-HOME® (1-800-469-4663).

Pedestal

Height

Approximate height

with washer

Color Model

Number

10.6"

(27 cm)

48" (122 cm) Imperial-

Silver

592-190070

10.6"

(27 cm)

48" (122 cm) Blue-

Silver

592-190080

10.6"

(27 cm)

48" (122 cm) Tango-

red

592-190040

10.6"

(27 cm)

48" (122 cm) Night Sky

Blue

592-190090

Stack Kit

Are you on planing stage to stack your Kenmore washer and dryer?

To do so , purchase an optional stack kit (Model:592-188800)

from your local Sears store or Sears Service Center. Follow

instructions included with the kit. See “Location Requirements.”

Location Requirements

Selecting the proper location for your washer improves

performance and minimizes noise and possible washer “walk.”

Your washer can be installed under a custom counter, or in a

basement, laundry room, closet, or recessed area. See “Drain

System.”

Companion appliance location requirements should also be

considered. Proper installation is your responsibility.

You will need

■ A water heater set to deliver 120°F (49°C) water to the

washer.

■ A grounded electrical outlet located within 6 ft (1.8 m) of

where the power cord is attached to the back of the washer.

See “Electrical Requirements.”

■ Hot and cold water faucets located within 4 ft (1.2 m) of the

hot and cold water ﬁll valves, and water pressure of 20-100

psi (137.9-689.6 kPa).

ENGLISH

Optional pedestal

Kenmore_Washer_Good-02681B-02_EN.indd 5 2009-07-23 ¿ÀÈÄ 4:17:56

1 2 3 4 5 6 7 8 9 10 ... 59 60

Comments to this Manuals

No comments

Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Washing machines Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS