Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual download pdf (Page 9)

INSTALLATION INSTRUCTIONS

Remove Transport System

WARNING

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

IMPORTANT: Position the washer so that the rear of the unit is

within approximately 3 ft (90 cm) of its ﬁnal location.

Before using your Washer, you must remove the four shipping

bolts from the back of the unit.

1. Loosen all the bolts with the supplied wrench.

2. Slide the bolt and spacer up and remove the bolt with the

spacer through the hole in the rear wall of your washer.

Repeat for each bolt.

3. Fill the holes with the supplied plastic covers.

4. Keep the shipping bolts and spacers for future use.

Connect the Inlet Hoses

Connect the inlet hoses to the water faucets

Make sure the washer drum is empty.

1. Check the inlet hose to ensure a washer is inside each ﬁll

hose.

Thread the inlet hoses to the HOT and COLD faucet

connections.

On the other end of the hose, check for one rubber washer

per hose and install each ﬁll hose to the water valve. Make

sure the hose with the Hot printed line is attached to the HOT

faucet. Tighten by hand until snug, then two-thirds of a turn

with pliers.

NOTE: For correct water use, connect both HOT and COLD

water valves. If either or both are not connected, an “nF” (no ﬁll)

error can occur.

2. Turn on the “HOT” and “COLD “water supply and check all

connections at the water valve and the faucet for leaks.

NOTE: Do not overtighten or use tape or sealants on the valve.

Damage to the valves can result.

ENGLISH

Cold Hot

Rubber washer

Cold printed Hot printed

Kenmore_Washer_Good-02681B-02_EN.indd 9 2009-07-23 ¿ÀÈÄ 4:18:01

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

No comments

Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual Page 9