Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual download pdf (Page 14)

B. REMOVE SHIPPING STRAP

IVt,J,i'm,_-" "-I_ =[=:J[i"

Removing the shipping strap is

necessary for smooth operation,

If the shipping strap is not

removed, the washer will make

excessive noise,

To prevent floor damage, set washer onto

cardboard before moving across floor.

Move washer close to its final location.

STEP 1. Do not cut yellow strap. Pull

yellow strap firmly, until completely

removed from washer. Depending on

your model, there should be either two

or three cotter pins on the end of the

shipping strap when it is pulled out of

the washer, The electrical plug is

attached to this shipping strap.

Electrical plug

STEP 2. Pull firmly to remove the

other end of the shipping strap pinned

to the back of washer. This will

release the rear self-leveling legs.

STEP 3. Cut the shipping strap about

16 in (40 cm) from plug end. Look for the

words "CUT HERE." Discard end with the

cotter pins. Slide remainder of shipping

strap free from the electrical plug. You

will use this to secure the drain hose.

ippingstrap

PULL

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 48 49

No comments

Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual Page 14