Sears Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual download pdf (Page 28)

CHOOSING CYCLES (Continued)

EXPRESS WASH

Fast cleaning starts with a continous

spray of water and detergent mixture as

the load is spun at low speed. Choose 4

to 10 minutes of wash time for small,

lightly soiled loads that need refreshing.

For the fastest cycle, select small water

level and warm wash, The preset wash

time for this cycle is 4 minutes.

WHITEST WHITES

i-lu-vum" "-I=4 i [:4 i'[,

Detergent and bleach are dispensed at

the proper time for the best possible

performance.

This cycle introduces liquid chlorine

bleach to the load sooner than the other

cycles for improved whitening of your

heavily soiled white fabrics, For maximum

soil and stain removal, liquid chlorine

bleach must be used. The preset wash

time for this cycle is 12 minutes.

CUSTOM SET

This cycle allows you to store a

customized wash cycle.

To Custom Set a wash cycle:

STEP 1. Select cycle.

STEP 2. Select the desired Options.

STEP 3. Select the desired Modifiers.

STEP 4. Press and hold CUSTOM SET

until a beep sounds (approximately 3

seconds).

STEP 5. Press START.

The Custom Set cycle is now stored for

future use. To reuse, select CUSTOM SET

and press START.

CHOOSING OPTIONS

Use this control to select

the desired options for

your wash cycle.

OPTIONS

CATALYST TM

flu-rum,- "-I=4 i [:4 i'[,

CATALYST TM allows soap

to soak and penetrate the entire load

providing improved stain and soil

removal,

28

CATALYST TM uses your detergent in a

unique way. Water flushes the detergent

from the dispenser to dissolve the deter-

gent. Then the detergent mixture is

sprayed onto the load while the washer

spins at low speed.

CATALYST TM will last 1 to 5 minutes

depending on the cycle selected. The

washer then stops spinning and fills to the

selected water level and continues wash-

ing with the selected cycle.

NOTES:

• For best results with

CATALYST TM , the load should be dry at

the start of the cycle.

• The CATALYST TM process reduces the

need for pre-treatments. Stubborn and

set-in stains may require additional

treatment.

SOAK

Use SOAK for set-in stains and soil that

need extra time for removal. The SOAK

option can be used in two different ways:

• Choosing SOAK with a cycle gives a brief

period of soak added to the wash time.

• Choosing SOAK only gives up to 60

minutes of soak time. SOAK only should

be followed by a wash cycle with

additional detergent added.

SOAK with a cycle:

STEP 1. Place a load of sorted clothes in

the washer. Add measured detergent to

the detergent dispenser.

STEP 2. Select the cycle you want by

_ressingone of the pads under

ELECT CYCLE.

STEP 3. Select SOAK from the

Options pads.

STEP 4. Select the desired WATER

LEVEL, WASH/RINSE TEMP and

AGITATION TIME from the

Modifiers pads.

STEP 5. Press START. The washer will

agitate briefly and then begin the SOAK.

The amount of soak time varies for each

cycle but is not longer than 12 minutes.

After soaking, the washer will agitate

again, then drain and spin.

SOAK only:

STEP 1. Place a load of sorted clothes

in the washer. Add measured detergent to

the detergent dispenser.

STEP 2. Select SOAK from the

Options pads.

STEP 3. Select the desired

WATER LEVEL.

STEP 4. Choose the desired soak

temperature from the WASH/RINSE

TEMP pad.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 48 49

Comments to this Manuals

No comments