
10
OutsideOutside
OutsideOutside
Outside
—Occasionally wipe with a mild
nonabrasive detergent and water. Rinse and dry.
Models with Stainless Steel
Door—Clean stainless steel with hot, soapy
water and a dishcloth. Rinse with clean water and
a cloth. Do not use harsh scrubbing cleaners. Use
only kitchen cleaners made especially for cleaning
stainless steel.
InsideInside
InsideInside
Inside—The inside of the dishwasher,
including the filter, is self-cleaning with normal
use. If needed, clean around the tub gasket area
with a damp cloth.
Note: Hard water may cause lime deposit buildup
on the interior of the dishwasher. For cleaning
instructions see ‘‘Removing Spots and Film’’
section.
CarCar
CarCar
Car
e of Drain Air Gape of Drain Air Gap
e of Drain Air Gape of Drain Air Gap
e of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. A drain air gap is
usually mounted on countertop and can be
inspected by removing the cover. This is not part
of your dishwasher and is not covered by
warranty.
Heating element
Filter
Spray arm/tower assembly
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Burn Hazard
OverOver
OverOver
Over
fill Prfill Pr
fill Prfill Pr
fill Pr
otectorotector
otectorotector
otector—Keeps
dishwasher from overfilling
and is located in the left front
corner of the tub.
• Clean occasionally with
household cleaner
containing vinegar or
bleach to dissolve any
buildup.
• Overfill Protector should move up and down
freely about one inch. If it does not move,
lift and clean underneath.
CarCar
CarCar
Car
e and Cleaninge and Cleaning
e and Cleaninge and Cleaning
e and Cleaning
WW
WW
W
interizinginterizing
interizinginterizing
interizing
A dishwasher left in an unheated place should
be protected from freezing. Have a qualified
person do the following:
TT
TT
T
o Disconnect Sero Disconnect Ser
o Disconnect Sero Disconnect Ser
o Disconnect Ser
vice:vice:
vice:vice:
vice:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or
tripping circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installations Instructions for more
details
.
TT
TT
T
o Restoro Restor
o Restoro Restor
o Restor
e Sere Ser
e Sere Ser
e Ser
vice:vice:
vice:vice:
vice:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a NORMAL cycle.
4. Check connections to make sure they do not
leak.
Note: See Installations Instructions for more
details.
Property Damage Hazard
Freezing temperatures may cause water lines
to rupture. Be sure all supply lines to and
circulating lines within dishwasher are
protected.
Failure to do so could result in property
damage.
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH
Comments to this Manuals