ASSEMBLY
TO INSTALL THE SHIFTER LEVER
• Stand the snow thrower up on the front of the auger
housing, as shown in FIG.8A. Note: Place a piece of
cardboard under front to prevent paint damage to
auger housing.
• Cut the plastic tie which holds the shifter lever
assembly to the shift bracket (FIG. 8B).
• Remove the locknut, washer, spring and bolt
(FIG. 8D).
• Reposition the shifter lever into the slot in the
control panel, as shown in FIG. 8C, and reinstall the
bolt, spring, washer and the locknut.
• Tighten the locknut until 1 /8" to 3/16" (2 or 3 threads)
of the bolt protrude past the locknut.
• Thread the shifter lever knob onto the threaded end
of the shifter lever until it is tight (FIG. 8D).
• Move the shifter lever through all the speeds to
ensure proper tension of the spring. If the shifter
lever sticks in any of the notches, loosen the
locknut 1/4 turn at a time until the shifter lever moves
freely.
• Return the snow thrower to the normal operating
position.
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger clutch lever and
Taction clutch lever may need to be adjusted before you
jse your snow thrower.
For instructions on checking or adjusting the control
:ables, see To Adjust Clutch Control Cables paragraph in
he Service & Adjustments section of this manual.
✓ CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
SNOW THROWER. WE WISH TO ASSURE THAT YOU
DECEIVE THE BEST PERFORMANCE AND
SATISFACTION FROM THIS QUALITY PRODUCT.
^LEASE REVIEW THE FOLLOWING CHECKLIST:
^ All assembly instructions have been completed.
^ The discharge chute rotates freely.
^ No remaining loose parts in carton.
UHILE LEARNING HOW TO USE YOUR SNOW
fHROWER. PAY EXTRA ATTENTION TO THE
-OLLOWING IMPORTANT ITEMS:
Engine oil is at proper level.
V Make sure gas tank is filled properly with clean, fresh,
unleaded gasoline.
'✓ Become familiar with all controls-their location and
function. Operate controls before starting engine.
FIG.8
TO INSTALL SHIFTER LEVER KNOB
• Thread the shifter lever knob onto the threaded end
of the shifter lever until it is snug against the hex nut
and the lip is pointed toward the engine. Tighten the
hex nut against the bottom of the shift lever knob (See
Fig. 9).
SHIFTER
KNOB
HEX NUT
HIFTER
LEVER
(36 pages)
(58 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals