Sears 934.5512559 User Manual download pdf (Page 13)

If your cable service supplies you with a cable converter box, you can use the basic connection shown below.

TO RECORD AND VIEW A SCRAMBLED/UNSCRAMBLED CHANNEL.

I. Press TV/VCR button so that "VCR" appears on the

display.

2. Set the TV channel to the same video output channel

as the switch located on the back of the VCR (CH3

or 4).

3. Set the VCR channel selector to the output channel

of the Cable Converter box. (EXAMPLE CH3)

4. Select the channel to be recorded at the Cable Con-

verter Box.

NOTES:

• With this connection, you CANNOT record one

program while viewing another.

• Channel memory programming is NOT needed when

using this connection.

CableTV To VCR'sANT,IN Terminal

ConvenerBox I

:::i-i'.illl

/ / _ Jack

CATV(Cable) To VCR'sANT.OUTTerminal

Input

CONTROLLING VCR INPUT & OUTPUT

When the VCR isin the Playback mtxie, or when the TV/VCR button is in the VCR position,

your TV will receive the signals from the VCR on either channel 3 or 4. Set the 3CH/4CH

selector switch to the stationthat is not used fornormal broadcasts in your area; then set your CH3 CH4

TV to that same channel when viewing from the VCR.

The video output channel of this unit is set to channel 3 prior to shipment from the factory.

To use the external input jacks, select the "LI" or "L2" position.

• If you use the audio and video input jacks on the back of the unit, press 0, 0, I with number buttons to select

the "LI" position.

• If you use the audio and video input jacks on the front of the unit, press 0, 0, 2 with number buttons to select

the '%2" position.

You can select "LI", '%2" as a channel by using the CHANNEL "A" or "V" button.

Note: "I.,1" and "I.,2" are found before the lowest memorized channel. (Example: CH2)

[vdI I) _Ol_V_[0] |] N _ N mKN H[0]_1 [0]_1MIk"i

TV power must be on. Please see your TV's owner's manual/or details.

To Set TV to the Video Mode

your

Connection Using AV Cord Set your TV to the Video mode using TV/VCR buttonof your 'IV.

(Refer to page 12.) To set your TV to the TV mode, press TV/VCR button of your TV again.

Connection Without AV Cord Set the TV channel to the same video output channel located on the back of the VCR.

(Refer to page 10, Ii, 13.) (CH 3 or 4) Then, set your VCR to the VCR mode using TV/VCR button of your VCR.

- 13- EN

***** 5C16

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments

Sears 934.5512559 User Manual Page 13

Comments to this Manuals

Related products and manuals for CRT TVs Sears 934.5512559