Sears 934.5512559 User Manual download pdf (Page 28)

JUST-IN TIME RECORDING

This function allows you to fully utilize the available tape length for timer recording. The VCR calculates the

remaining tape amount and then adjusts the tape speed from SP to SLP as needed.

If it is suspected that the end of the tape will be reached before the reserved program ends (as long as SP mode is

kept all the way), set recording mode to AUTO. This function is available only with Program No. 1 and Quick Set

Program.

The auto mode starts recording in SP mode. The internal circuit compares the rest of the program against the

available tape length. If the internal circuit determines that the available tape is not long enough to record the

program in the SP mode, the Recording mode is automatically changed to SLP mode. This will assure coverage

of the desired timer program before the end of the tape is reached.

Conventional Video Recording

Recording In SP mode for 40 minutes

Tape End

20minutesoftheprogramis

left unrecorded

Just-In Time Recording

Recording In SP mode

for 30 minutes

Recording in SLP mode

for30minutes

_.. Recording mode automatically

changes to SLP mode

Notes:

• Set the tape remainder switch ("~TI30" or "I'140J') to the tape loaded.

• Even if SLP mode is selected, just-in time recording cannot compensate for a tape length which may be too

short.

• A momentary picture break up will occur at the point on the tape when the recording speed changes from SP

to SLP.

• The displayed remaining tape running time may not always match the actual remaining time on the tape (usually

longer than the actual time). It is recommended to set the end of the reserved recording time several minutes

after the end of the TV program.

- 28 - EN

_.¢r_ 5B24

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Sears 934.5512559 User Manual Page 28