Sears 358.357182 User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
в. STARTING INSTRUCTIONS (Йе1ег to “Specifications for location of controls.)
1. BASIC PSOCSDURE
a. Hold saw firmly writh the sw chain free to turn
without contacting any obfect.
b. Move ignition twitch to “Start" position .Figure 15.
c. Adjust choke according to "Staning Procedure lor
\^fyifig Conditions (S^p 2)**.
d. Sgueexe trigger with your light hand'vhile pushing
sawawiyhomyouaRdpulIingthestaiterropewith
youriefthand.Figtitt 14.
c. Release tiietrtggefaftefenginestiiits,aifowing the
engine to idle.
^WARNING
The chain must notmove when the engine runs at idle
speed. Refer to "Carburetor Adjustments,"' for
coneetfon.
f. Stop engine by moving the ignition switch to the
“Stop" position. Figure 15.
s«w «waf wi*n ngw
tiana «mila pitiiing sunat
rpp«
«Riti Iti! Папб.
Figure 14
Uaa ooh iSlSincnes
el root par pull.
iCNItlQN SWITCH
CHOKE
A
Li .
START -fci STOP
I '■ half
OFF
Awarning
Always wear gloves; safety footwear; snug^fitting
clothing; and eye, hearing,, and head protection
devices when openting a chain saw.
Figure IS
Awarning '
Avoid bodiiyeontact with ihemuffler when staningor
using a warm engine to avoid seriaus bums,
b. WARMBiOIHE
. l)Leavschokeat№eoifpdsition.Fgur81S-
2.) Puil warier rope unw engine runs.
2. STARTING PROCEDURE FOR VARYING CONDITIONS
NOTE; 6e sure to fotfOw “1. Basic Procedure," as
desenbed on this page.
a. COLO ENGINE
1 ) PuUchOKe to full choke position Figure iS.
2 ) Puli starter rope until engine attempts to run
3. ) Push Choke until half position is felt. Figure tS.
4. ) Pull starter rope until engirt runs.
5. ) After S second warm up, push choke to ihe
oti position.
C. REFUELED WARM ENGINE AFTER RUNNING
OUT OF FUEL
1.) Pull choke K> full choke posRion. Rgure i S.
Е.)РиП staner rope unul engme ahempis to run
3.1 Push choke to the oil position. Figure 1S.
4) Pull staner rope unw engme fens.
3. IMPOFTTANT POINTS TO RBiEMBER
a. When puDmg Ihe starter rope, do not use the f u!
eidentof tfie rope as the can cause the rope to огеак
Do nonet the staner rope snap back. Hold the han
^e and let the rape rewind Slowly.
B. If engine floods, let the unitsitfora few minutes
then repeat seeing procedure using the naif
chofQBp^ion.
For eeiid weather ataiting, alcwr engine to warm ui
(1ЦЙ min.) ati>whalki»kB position, then rnaecho»
©d»odpositkm,Dotic*ctrtiwtthithe choketat th*
‘fuir or “half position.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments